Updating bin files captiveworks cw 700s

27-Oct-2019 23:12

First do a factory reset of your Coolsat to return it to the factory default settings (not to be confused with loading the factory bin file which should not be necessary) then follow these directions to update your current bin file with the rq-coolsat firmware that was included in your download for your Coolsat model.03. With all power OFF, connect the RS232 straight through serial cable from the Coolsat to your PC 05. Start the Coolsat Pro Loader v2.4 software (FIGURE C BELOW).

Check the tab "To Receiver" With your Coolsat Receiver still turned off and connected to your PC via a DB9 RS232 straight through serial cable do the following to PREPARE YOUR COOLSAT FOR LOADING A CHANNEL LIST.

The Captive Works receiver has an internal memory that is expandable to 8 GB, a 1 GB flash drive and a Sempron 3000 processor.

The receiver also has connection ports for VGA/HDMI or DVI/component/S-video for use with most digital format TVs.

updating bin files captiveworks cw 700s-9

After clicking on the new folder icon you will then see a folder appear with the words new folder.Then go to the software update and run it like you are updating a bin. Turn your receiver off from the switch on the back. Then turn on the receiver and flash it with bin (417 Elite), (514 HD8000), (420 Premier).When it asks to reboot, turn off with the back switch again. At this point it is a New Link at version 1.2 Turn the receiver on. */ .calendar .calendar table /* Header part -- contains navigation buttons and day names. Put it on a usb flash drive and plug it into your receiver.

After clicking on the new folder icon you will then see a folder appear with the words new folder.Then go to the software update and run it like you are updating a bin. Turn your receiver off from the switch on the back. Then turn on the receiver and flash it with bin (417 Elite), (514 HD8000), (420 Premier).When it asks to reboot, turn off with the back switch again. At this point it is a New Link at version 1.2 Turn the receiver on. */ .calendar .calendar table /* Header part -- contains navigation buttons and day names. Put it on a usb flash drive and plug it into your receiver.Once saves the name and the second opens the folder.